Leave a Message
We will call you back soon!
Your message must be between 20-3,000 characters!
Please check your E-mail!
More information facilitates better communication.
Submitted successfully!
We will call you back soon!
Leave a Message
We will call you back soon!
Your message must be between 20-3,000 characters!
Please check your E-mail!
—— Fikret
—— Nadim
—— ngyum
—— Sanjay
—— tim
—— cagin
—— praveen
—— pawan
—— abbas
—— mohamed
—— Addy
—— MIN KEE KIM
—— adam phelan
—— Antonio C. Cuyegkeng
—— Andrzej Danielewicz
Attention:
1. The printer should be careful when using and installing the stencil. The mixing knives should not be placed on the steel mesh to prevent damage to the stencil and scraper when the squeegee is pressed down. Special attention should be paid to the placement of the thimble. Other debris other than the thimble should not be placed under the steel mesh.
2. Every time the steel mesh is used, the surface, side surface and steel mesh hole of the steel mesh should be carefully cleaned. In particular, the steel mesh hole needs to be cleaned with a toothbrush to prevent the solder paste from being clogged and affecting the tin. The steel mesh should be stored on the steel grid, and the side of the logo should be on the outside for easy searching.
Factory Address:HENGFENG INDUSTRIAL AREA,ZHOUSHI ROAD NO. 739,HEZHOU COMMUNITY,HANGCHENG STREET,BAOAN,SHENZHEN,CHINA | |
Sales office:HENGFENG INDUSTRIAL AREA,ZHOUSHI ROAD NO. 739,HEZHOU COMMUNITY,HANGCHENG STREET,BAOAN,SHENZHEN,CHINA | |
+0086-136-70197725 | |
linda@eton-mounter.com | |