Leave a Message
We will call you back soon!
Your message must be between 20-3,000 characters!
Please check your E-mail!
More information facilitates better communication.
Submitted successfully!
We will call you back soon!
Leave a Message
We will call you back soon!
Your message must be between 20-3,000 characters!
Please check your E-mail!
—— Fikret
—— Nadim
—— ngyum
—— Sanjay
—— tim
—— cagin
—— praveen
—— pawan
—— abbas
—— mohamed
—— Addy
—— MIN KEE KIM
—— adam phelan
—— Antonio C. Cuyegkeng
—— Andrzej Danielewicz
Reflow soldering--the first choice for ETON
Reflow oven apply to smt production line, and the most using model is 8 zones, it is suitable for most of prodution line.
Features
1. It has a time-delay switch protection function to prevent the transmission parts from deforming due to uneven cooling.
2. It has a power-off protection function to ensure the normal output of the PCB board without damage after power-off.
3. It adopts imported high-speed air-carrying motor direct drive for thermal cycle, low noise, low vibration and high thermal cycle efficiency.
4. All temperature zones are heated separately up and down, independent hot air circulation, independent temperature control, and the temperature control accuracy of each temperature zone is ±1℃.
5. Dedicated temperature acquisition module, high accuracy and fast speed, with cold junction compensation function.
6.Imported high-quality high-temperature-resistant motor with good structure and good heat dissipation to ensure its service life and reliability. The direct connection mode connects the wind wheel with a speed of up to 2800rpm to provide sufficient hot air flow.
Precautions for reflow soldering operation:
1. Do not touch the mesh belt during the operation, and do not let water or oil stains fall into the furnace to prevent burns.
2. Ventilation should be ensured during welding operations to prevent air pollution. Operators should wear work clothes and masks.
3. Frequently inspect the heating wire to avoid aging and leakage.
Factory Address:HENGFENG INDUSTRIAL AREA,ZHOUSHI ROAD NO. 739,HEZHOU COMMUNITY,HANGCHENG STREET,BAOAN,SHENZHEN,CHINA | |
Sales office:HENGFENG INDUSTRIAL AREA,ZHOUSHI ROAD NO. 739,HEZHOU COMMUNITY,HANGCHENG STREET,BAOAN,SHENZHEN,CHINA | |
+0086-136-70197725 | |
linda@eton-mounter.com | |