Leave a Message
We will call you back soon!
Your message must be between 20-3,000 characters!
Please check your E-mail!
More information facilitates better communication.
Submitted successfully!
We will call you back soon!
Leave a Message
We will call you back soon!
Your message must be between 20-3,000 characters!
Please check your E-mail!
—— Fikret
—— Nadim
—— ngyum
—— Sanjay
—— tim
—— cagin
—— praveen
—— pawan
—— abbas
—— mohamed
—— Addy
—— MIN KEE KIM
—— adam phelan
—— Antonio C. Cuyegkeng
—— Andrzej Danielewicz
Large factories or in the engineering in the use of SMT placement machine, usage will gradually become worse at any time.Most of the cases are caused by the influence of the environment. On the other hand, dust is not cleaned in time, and a large amount of dust or oil stains generated inside the machine will affect the performance of the machine. These factors will affect the service life of the machine.If not strictly in accordance with the maintenance method of the placement machine, not only will affect the normal work of the placement machine, but also will lead to some parts of the machine internal excessive strain or accident, in order to avoid this situation, must be combined with scientific maintenance of the machine maintenance.
1. Carefully clean the dust and dirt generated on the surface of the machine and the electric plate, so as to avoid dust and oil dirt entering the internal parts of the machine and avoid damage caused by overheating of the motor.
2. Solenoid valve and vacuum device shall be thoroughly disassembled and cleaned to avoid blockage caused by scale, resulting in component strain.
3.How to maintain SMT mounter regularly:
4.First, take out the Nozzle. Wait until the Nozzle is turned OFF. At this time, take OFF the Nozzle and put the "HEAD SERVO" OFF. Then go to the Nozzle.
5.Use the manual handle to turn the head between positions 7 and 8.Use a mirror to place it on the platform below the head.The reason for doing this is to facilitate the search for screws.
Loosen the bottom screw with the M5 trapezoidal hexagon wrench and remove the retaining block.
6. Use a spanner in one hand to press the slider on the head, and hold the head in the other hand so that it can be pulled out slowly.
7. Press the trachea interface with needle-nozzled pliers, pull out the trachea and remove the sticker head.Note: It is difficult to take out the trachea of the first sticker, so please pay attention not to loosen the connecting head of the inner side trachea.
Factory Address:HENGFENG INDUSTRIAL AREA,ZHOUSHI ROAD NO. 739,HEZHOU COMMUNITY,HANGCHENG STREET,BAOAN,SHENZHEN,CHINA | |
Sales office:HENGFENG INDUSTRIAL AREA,ZHOUSHI ROAD NO. 739,HEZHOU COMMUNITY,HANGCHENG STREET,BAOAN,SHENZHEN,CHINA | |
+0086-136-70197725 | |
linda@eton-mounter.com | |