Leave a Message
We will call you back soon!
Your message must be between 20-3,000 characters!
Please check your E-mail!
More information facilitates better communication.
Submitted successfully!
We will call you back soon!
Leave a Message
We will call you back soon!
Your message must be between 20-3,000 characters!
Please check your E-mail!
—— Fikret
—— Nadim
—— ngyum
—— Sanjay
—— tim
—— cagin
—— praveen
—— pawan
—— abbas
—— mohamed
—— Addy
—— MIN KEE KIM
—— adam phelan
—— Antonio C. Cuyegkeng
—— Andrzej Danielewicz
The Installation of led Strip
1. When the LED lamp belt is one roll, please do not light the lamp belt.
2. Only in the lamp belt lamp body printed with scissors mark cut, otherwise it will cause a unit not bright.
3. During installation, bend the lamp belt to one side to expose 2-3MM copper wire, and cut it clean with scissors without burrs to avoid short circuit.
4. Do not connect the power during the installation or assembly of the lamp belt. Only connect the power when it is properly installed,
5. When installing LED lamp belt in cold temperature, power on for a few minutes to make the lamp body soft and easy to bend, and then power off for installation.
6. During installation and use, do not hit the tube with heavy objects, and do not shake.
7. The end of the tube must be glued securely before the tail plug is used.
8. Only two tubes with the same specifications and the same voltage can be connected to each other in series. The total length of the series cannot exceed the maximum allowable length
9. The interfaces must be secure and free from potential short circuit. When outdoor installation is performed, the interfaces must be sealed with glass glue or other appropriate methods to ensure water intake.
10. Do not install in water, flammable, explosive environment, must ensure good ventilation environment.
11. When installing and fixing, do not use metal materials such as iron wire to tighten the lamp tube, so as not to sink the wire into the lamp tube and cause short burning of the lamp tube.
12. The supply voltage should be consistent with that indicated on the lamp tube, and an appropriate safety device should be installed.
13. During the use of the lamp tube, do not use any object to cover the lamp tube.
14. If you find that the lamp body is damaged, please cut off this part immediately. Do not continue to use it to avoid danger.
15. If you need flash, water and other effects, please use LED controller.
Contact David:+86 13827425982
Factory Address:HENGFENG INDUSTRIAL AREA,ZHOUSHI ROAD NO. 739,HEZHOU COMMUNITY,HANGCHENG STREET,BAOAN,SHENZHEN,CHINA | |
Sales office:HENGFENG INDUSTRIAL AREA,ZHOUSHI ROAD NO. 739,HEZHOU COMMUNITY,HANGCHENG STREET,BAOAN,SHENZHEN,CHINA | |
+0086-136-70197725 | |
linda@eton-mounter.com | |